1. 1 Description

Model 1011 NIM Power Supply provides +/- 12 volts at 2 amperes, each, +/- 6 volts at 5 amperes each, and 24 volts at 1 ampere in accordance with AEC - NBS Standard TID-20893 Type V-H. Total power capability is 96 watts, which is available for any combination of the six voltage outputs.

The electronic circuit regulators for the six power supplies are contained on a single printed circuit board. Voltage adjustment potentiometers allow variation of the output voltages by approximately +/- 2%.

All voltages incorporate over-current protection and no damage to the supply will result in the event of a continuous short circuit condition. A thermal warning and thermal cutoff switch is provided to protect the power supply should the internal temperature exceed safe limits, Over-voltage protection is provided for the + 6 volt and - 6 volt supplies.
1. 2 Specifications
Detailed performance and physical specifications of the Model 1011 NIM Power Supply are provided in Table 1. 3 Accessories
One operating manual

Specifications
 

Outputs	D. C.: + 24 volts and - 24 volts at 0 to 1 amp + 12 volts and - 12 volts at 0 to 2 amps +6 volts and -6 volts at 0 to 5 amps
Power:	96 watts maximum
A. C.:	115 volts at line frequency
Connector	Amp 202651-2
Regulation line and load	+/-.005%, + .5mv (at sense points)
Temperature Coefficient	50 PPM/'C or +/- .005%/'C
Ambient Operating Temperature	-20'C to +50 'C derating: 2%/'C to 60'C
Noise and Ripple (dc to 50 mHz)	3mv pk to pk
Recovery Time	returns to within 1% of output within 50 microseconds for a load change of 10% to 100%
Input Line Voltage	103 to 129 or 206 to 258 VAC, 47 to 65 Hz single phase
Input Power	250 watts at maximum load conditions
Physical Size	3-7/16" H x 7-1/2"D x 16.840"W Weight: 18 lbs.
Option P	Output Connector PG-15 supplied

---

Up to a higher level directory  | |  For more information