POWERED CAMAC CRATES
POWERED CAMAC CRATES
* Switching/linear power supply.
* High efficiency.
* Meets or exceeds IEEE standard 583.
* 650 or 800 watt continuous power output.
* Full power at up to 50 degree C ambient.
* Modular,easily maintained power supply.
* Interchangeable power supplies.
* Microprocessor metering/fault sensing.
* Dataway-readable crate status byte.
* Air temperature/flow sensor
* Individual fan fail sensors.
* Assembly with six 115 CFM fans.
* Planarized air flaw for uniform cooling.
* Front, bottom, or side air intake.
* Module connectors with replaceable pins.
* Tapped CAMAC module mounting holes.
* Facilitates NIM modules, and "Viking"
connector assemblies.
The Highland M2560/2585 CAMAC crates are high powered, fully featured card cages and power supplies capable of supporting up to 25 standard CAMAC (IEEE 583) data acquisition and control modules.
This family of CAMAC crates is designed for maximum reliability under demanding conditions of full power output and high ambient temperature. High-efficiency switching regulators are used for the plus and minus six volt supplies, providing up to 85 amp output on either polarity. Linear regulators are used in the 12 and 24-volt supplies, providing good efficiency and excellent noise and transient performance. These crates meet the IEEE 583 specification limits for noise and transient response on all supplies; this performance, combined with superior module cooling and advanced CAMAC Crate features, make the M2585 an ideal choice for high reliability Transient Digitizer and Data Logger Systems.
OUTPUT VOLTAGES:
+ 6.00 volts; 0-85 amps or 0-60 amps ) shared to 800 ) - 6.00 volts; 0-85 amps or 0-60 amps ) or 650 w. max. ) ) shared to + 12.00 volts; 0-10 amps ) ) 800 or 650 - 12.00 volts; 0-10 amps ) shared to 240 ) watts max + 24.00 volts; 0-10 amps ) watts max. ) - 24.00 volts; 0-10 amps ) ) POWER SUPPLY EFFICIENCY: Typically 7% at rated load. NOISE/TRANSIENTS : Conforms with IEEE 583 limits. Peak to peak for any supply does not exceed 15 mV P-P at 50 MHz bandwidth. REGULATION AND STABILITY: Exceeds the requirements of IEEE Standard 583- 1982. OPERATING TEMPERATURE RANGE: 0 TO 50 degrees C. Derate to 40 degrees C at 8,000 feet. PROTECTION ON ALL SUPPLIES : Current limiting on all outputs. High temperature shutdown. Low line voltage shutdown. Output overvoltage crowbar. Reverse voltage protection. Line surge limiting and regulator soft start. Fusing on AC line and individual regulators. Remote sensing with open sense circuit protection. METERING PROVISIONS : Large 8-character alphanumeric display indicates the following variables, and alarm out-of-limit conditions: All output voltages and currents. Total power output in watts. AC line voltage. Power supply internal temperature. Power supply summary status. Model and serial number. Optional intake air temperature and flow status. Optional individual fan failure sensing. IMPUT VOLTS: 120 OR 240 VRMS, 50/60 HZ, switch selectable. DIMENSIONS : 19.0" wide by 21.4" deep by 12.25" (7U) high. LED INDICATORS POWER ON / WARNING / HIGH TEMP MODEL NUMBERS : # M2585 = 85 AMP, 800 Watt, 6 FANS. # M2560 = 60 AMP, 650 Watt, 6 FANS. OPTIONS : Crate status bit relay output. Dataway-readable crate status byte. Individual fan failure sensors with summary alarm and air temperature metering. Side air intake. Audible trouble alarm.